Centroid Community CNC Support Forum

Good morning:

I have Centroid Acorn v 5.06 running a Sherline Lathe. I have a TT4 and have read everything I can on setting Parameters 3, 18, 244 & 257 for this, but am confused. I've reviewed the newest Lathe Manual (v5.30+) and still not sure. TT4 manual says settings for parameter 44 (believe it ...

Thanks to all of you for your responses. I didn't think it mattered to set before or after the program was loaded, but needed some confirmation.

Tom

I am having issues with setting part zero and just trying to eliminate all possibilities. Sometimes X0Z0 is correct and sometimes X0 travels to the -X side of the part. When loading a lathe program created other than in Intercon (Fusion 360 in this case) is the part zero set before the program is ...

I mis-understood the install instructions. After loading the license it then tells you to download the new version, but doesn't state to close CNC12. Thanks for your help. I'm up and running.

Good evening:

I was in the process of installing v4.80 and received the attached error messages. I tried the install process again with the same result. Even tried the "Ignore" button, knowing it would help, but the install process continued to what was stated to be a "successful completion ...