Centroid Community CNC Support Forum

Very strange, now its working fine. I went back and removed the output assignment (using the wizard) then re-added them. I also manually inverted 5-8, then manually un-inverted them in the diagnostic screen. This also involved a couple of power cycles and software re-starts. Works now.

Thanks guys ...

Greetings fellow Acorn users, and thanks to all who provide feedback on this forum. I've got a problem with my outputs that I can't figure out.

I can get outputs 2-4 to fire from CNC 12. For example, if I set output 2 = coolant pump, then press the coolant icon the relay 2 opens fires. Same for ...

Thanks guys. I feel 33% better

Thanks for the suggestion. If all else fails, I might give this a try. Question: how did you diagnose the direction signal as the problem?

Below is an updated link to my Google Photo album. Hopefully this one works.

Greetings fellow Acorn users, and thanks to all who provide feedback on this forum. It's an incredible resource. I've been referencing several threads here and it got me ALMOST to the finish line.

Setup:
-2 axis lathe conversion from 12" Chinese 12x36
-Acorn Rev 4 (14455)
-CNC12 Lathe Version 4.20 ...

Hi Marty, thanks for all your hard work here in the Forums. I'm just getting around to wiring up my 2 axis 12x36 Lathe and your info has been awesome.

Acorn Controller
DMM DYN4 Drive
DMM 750W motors

I purchased my DMM hardware in Dec 2018 along with the CA-CUACRN-M4-1 cable. DMM provided this ...