Recently my new Centroid Acorn CNC system started to complain. After receiving help from Centroid plus doing some poking around, I found a double fault. Somehow a virus program had been installed and was active. I also bumped the Ethernet cable and it was not making full contact. All is well again. This was not a hassle, it was an opportunity to write up my debugging steps.
If you are interested, please see
http://rick.sparber.org/CAEF.pdf
Your comments are welcome. All of us are smarter than any one of us.
Thanks,
Rick
When the Centroid CNC Software Loses its Acorn (resolved)
Moderator: cnckeith
-
RGSparber
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
When the Centroid CNC Software Loses its Acorn (resolved)
(Note: Liking will "up vote" a post in the search results helping others find good information faster)