Page 1 of 1

AcornSix Board Bad

Posted: Sat Jul 29, 2023 6:16 pm
by usajet
Everything was working fine until I turned on the spindle board and the pwm connector started smoking and flashing. I had the PWM installed to the pwm2 pins. I had this same board working with the Acorn it should have worked with the AcornSix.

It has a error 6 but goes away. I can communicate with it but steppers don't move now. My System ID is 0008DC111213-0605230122.

Re: AcornSix Board Bad

Posted: Sun Jul 30, 2023 9:21 am
by cnckeith
looks like power got connected to the wrong place. email support@centroidcnc.com and ask for RMA to return it for repair.