Setting up a 4th Axis in Acorn and fusion360
Posted: Fri Jun 09, 2023 2:44 pm
Here is how I do this.
After setting up this way you can mill any part in the centric vise on the A-Axis without using a probe for each part.
If using Intercon use all dimensions from the center of the A-Axis and from X0 at the base of the vise jaws.
Uwe
After setting up this way you can mill any part in the centric vise on the A-Axis without using a probe for each part.
If using Intercon use all dimensions from the center of the A-Axis and from X0 at the base of the vise jaws.
Uwe