Page 1 of 1
170 volt dc
Posted: Mon Nov 10, 2014 2:51 pm
by JakesPorting
Ok so I am wiring and doing checks and I get 170 vdc out of the cap board.
The install manual states it should be max of 130 vdc is this going to be ok at 170 ?
Thanks Jake
Re: 170 volt dc
Posted: Mon Nov 10, 2014 2:59 pm
by Centroid_Liviu
What is the revision on your install manual? We switched to 180V max cap-boards over a year ago. Please take at the Tech Bulletin below for specifics and serial numbers of when the switch happened.
http://www.ajaxcnc.com/downloads/Techni ... ns/269.pdf
Re: 170 volt dc
Posted: Mon Nov 10, 2014 3:13 pm
by JakesPorting
Ok thanks I was just making sure don't want to blow anything up.
The revision on the install manual is 2-18-2014