Page 1 of 1
updated software now no stepper movement (Resolved)
Posted: Wed Nov 25, 2020 3:38 pm
by RKM 3D Designs
so i updated my software to 4.5 snipped all my settings re-entered everything, now the steppers wont move. the cnc12 software says all is good and when i move the axis in the program the numbers move and such, but no real world movement on the cnc.
any help would be awesome. i attached the report as it sit right now, i wont change anything until i get any info on what needs to change.
thank you in advance.
RKM
Re: updated software now no stepper movement
Posted: Wed Nov 25, 2020 9:28 pm
by galyion
i just had this same issue. did you set the correct connection db25 or screw terminal. if that's not it check your enable pins
Re: updated software now no stepper movement
Posted: Fri Nov 27, 2020 12:01 pm
by martyscncgarage
RKM 3D Designs wrote: ↑Wed Nov 25, 2020 3:38 pm
so i updated my software to 4.5 snipped all my settings re-entered everything, now the steppers wont move. the cnc12 software says all is good and when i move the axis in the program the numbers move and such, but no real world movement on the cnc.
any help would be awesome. i attached the report as it sit right now, i wont change anything until i get any info on what needs to change.
report_0035FF8A51A7-0821203657_2020-11-25_14-30-59.zip
thank you in advance.
RKM
Did you resolve this issue?
You didn't provide much information. What drives you have, where they were connected, you could have posted your screen shots BEFORE the upgrade and AFTER the upgrade.
Are you connected to Acorn DB25 or headers?
The report is not enough...
Re: updated software now no stepper movement
Posted: Tue Jan 26, 2021 1:54 pm
by RKM 3D Designs
yeah got this resolved sorry fell off the map there. all good machine rocks super good now.