Denford Novamill acorn retro fit
Posted: Tue Jun 16, 2020 9:08 pm
Hi All
Just wondering , has anybody here done a Denford Novamill - Acorn retrofit
I picked up one of these little mills with ATC a while ago and finally have the time to try and get it running.
I already have an acorn board that i am planning to use to replace the original controller but other than this and a few new stepper drives i'm hoping to use the majority of the original hardware ie: DC spindle control board , power supplies etc.
I'm slowly figuring out the original wiring etc but it would be great to pick someones brains who has done this all already !
Just wondering , has anybody here done a Denford Novamill - Acorn retrofit
I picked up one of these little mills with ATC a while ago and finally have the time to try and get it running.
I already have an acorn board that i am planning to use to replace the original controller but other than this and a few new stepper drives i'm hoping to use the majority of the original hardware ie: DC spindle control board , power supplies etc.
I'm slowly figuring out the original wiring etc but it would be great to pick someones brains who has done this all already !