Page 1 of 1
Curious: Is there retrofit flow chart for Centroid machine retrofit??
Posted: Sat Jul 06, 2019 9:08 pm
by frijoli
Due to work and health issues I have to leave my projects for periods of time and forget what's next.
My mill works but needs to be dialed in, my lathes are in various states.
I don't see anything in the AllInOne or Acorn manual. Is there such a thing out there?
Clay
Re: Curious: Is there retrofit flow chart for Centroid machine retrofit??
Posted: Sun Jul 07, 2019 9:09 am
by martyscncgarage
frijoli wrote: ↑Sat Jul 06, 2019 9:08 pm
Due to work and health issues I have to leave my projects for periods of time and forget what's next.
My mill works but needs to be dialed in, my lathes are in various states.
I don't see anything in the AllInOne or Acorn manual. Is there such a thing out there?
Clay
Clay, I suggest you use the All in One DC Installation guide. Follow it beginning to end. Put a sticky note with a date on it where you left off. The installation manuals were written with installation workflow in mind.
Marty
Re: Curious: Is there retrofit flow chart for Centroid machine retrofit??
Posted: Sun Jul 07, 2019 10:11 am
by frijoli
martyscncgarage wrote: ↑Sun Jul 07, 2019 9:09 am
Clay, I suggest you use the All in One DC Installation guide. Follow it beginning to end. Put a sticky note with a date on it where you left off. The installation manuals were written with installation workflow in mind.
Marty
Marty, that's too easy and makes too much sense. lol
Clay