Centroid Community CNC Support Forum

Morning,
This maybe my fault as I’m not familiar with the Intercon program.
When opening a new file/drawing in Intercon ….the default hook stays on screen.? I click File> New and I don’t get a blank screen start new drawing.
The hook stays on screen. When I import dxf it installs it over the hook? It did this also before the reinstall of Intercon.
This makes Intercon somewhat of a challenge to use!
Your help would be much appreciated….. Thanks Doug

When creating a file you will need to except the title and programer menu to get a new job.

If you just escape out then intercon will not create a new job.

Hi Joey,
Thanks for that info!
Now that I can open a clean drawing the previous problem of not being able to open a DXF file persists! Computer thinks for 30 sec or so then shuts down Intercon and I get the cnc12 screen.
Thanks

Do you get the same shutdown behavior when using F8 Graph? I'm wondering if this is a graphics driver issue.

Hi,
Yes the response is the same on the graph.
It’s a new computer and it so happens it wanted to do a rather long update to the drivers , was hopping for a miracle but not so, the same thing happens. Sometimes I get the almost the full dxf drawing downloaded…as soon as it’s almost finished it shuts down and reverts to the cnc12 screen. Thanks for the info
Doug

In which autocad version is the DXF file saved/exported ?

Uwe

If your computer has a separate graphics card, you might try a different one. If it's integrated graphics, do you have another computer you can try?

Hi,
Computer has integrated graphics card. Will see if I can try a different computer today.
Dxf files were exported in r13.
Thanks for your help ….Doug

Could you pls. try R12?

That version works best in the mill software. Also splines have to be converted into curves or small lines. CNC12 can only read arcs and straight lines.

Uwe