Centroid Community CNC Support Forum

Hello,

I'd like to mill 60 radial slots on my custom ABS ring. Basically everything is a lathe work except those slots. Is that something that's doable in intercon (acorn, most recent version of cnc 12)?
I don't have cnc12 in front of me now so I can't look around at the moment. The way I see it is either as a bolt hole pattern with pocket milling (under angle) if something like that exists or milling a slot and then looping while rotating geometry by 6 degrees in every iteration and I have no idea how to achieve that.

Thank you,
Bruno

Can you upload a drawing?

Pencil sketch will be ok also.

Uwe

Here we go.

This is easy to do.

Make one slot and use the rotate cycle.

Uwe

Much obliged! Had no idea about that feature.

Bruno