Page 1 of 1
Lathe profile 5.30
Posted: Sat Aug 09, 2025 2:02 pm
by PhilipTrueman
Can someone have a look at the screen shots and tell me if this should read "profile end" for the end of the lathe profile.
Version 5.30
Re: Lathe profile 5.30
Posted: Sat Aug 09, 2025 2:18 pm
by cncsnw
Not really. It is the same page you would see if you edit operation #2, "Profile". It is part of the same operation, so showing the cycle details when you highlight the "Profile End" marker and choose Edit is just a convenience.
Re: Lathe profile 5.30
Posted: Sat Aug 09, 2025 9:04 pm
by suntravel
Are you sure to want 1000 m/min CSS?
Uwe
Re: Lathe profile 5.30
Posted: Mon Aug 11, 2025 8:43 am
by PhilipTrueman
suntravel wrote: ↑Sat Aug 09, 2025 9:04 pm
Are you sure to want 1000 m/min CSS?
Uwe
It should have read 100 m/min
And 0.05 F/M
Looks about right for aluminium.
I am sure that the one shot chamfer cuts the aluminium diagonally
Just testing out the profile
Re: Lathe profile 5.30
Posted: Mon Aug 11, 2025 8:44 am
by PhilipTrueman
cncsnw wrote: ↑Sat Aug 09, 2025 2:18 pm
Not really. It is the same page you would see if you edit operation #2, "Profile". It is part of the same operation, so showing the cycle details when you highlight the "Profile End" marker and choose Edit is just a convenience.
I would have thought it should read profile end.