Page 1 of 1
C97 gecko g250x
Posted: Sat Jul 12, 2025 3:43 pm
by Oldman1965
I can’t seam to get my c97 g250x to run my motors I have a bi polar motors a 2315hs300aw-ob from open builds 1/8 step I am trying to use wizard and anything that I try I can’t seam to get it to work any help would be appreciated thanks.
Re: C97 gecko g250x
Posted: Sat Jul 12, 2025 5:03 pm
by Sword
Could use some more info, photos, and a report to be of more help.
Got your motor wire pairs correct, got a 48v power supply hooked to the C97, current set, wizard set to DB25 for signal mapping......?
Re: C97 gecko g250x
Posted: Sun Jul 13, 2025 7:05 am
by tblough
Are the motor drives connected to the DB25 plug!?
Re: C97 gecko g250x
Posted: Sun Jul 13, 2025 1:00 pm
by Sword
tblough wrote: ↑Sun Jul 13, 2025 7:05 am
Are the motor drives connected to the DB25 plug!?
Yikes, I would sure hope so.
CNC4PC C97
https://www.cnc4pc.com/shop/c97-board-c ... g250x-1658