Centroid Community CNC Support Forum

I am making the connections for a 2-axes(X y Z) torm with a Turret Model LD48-C6140, to make the connections of the 4 positions that the turret has that has those 4 inputs so that the PLC knows in which tool it is and with a sensor limits in the lower part for when I make Home
My question is to make the connection of:
Input 1- Turret
Input 2-- Turret
Input 3-- Turret
Input 4- Turret

Can I do it directly on the H4 and H6 connector?
Thank you so much

All depends on the type of signal. Are these simple switches? Are they PNP etc? Fundamentally yes to the question but depends on what type of switch it is.

You also mention 2 axis but then name X y and Z ....

Chaz wrote: ↑Tue May 27, 2025 3:16 am All depends on the type of signal. Are these simple switches? Are they PNP etc? Fundamentally yes to the question but depends on what type of switch it is.

You also mention 2 axis but then name X y and Z ....

It is possible that the OP is more used to Spanish and the "y" means "and" in this case. Which seems likely considering that this sounds like a lathe turret.

Ah, thanks.