I have a Grizzly 704 Mill and do not have home or limit switches yet. I want to set up my tool library. I have 123 block to touch off my tools but do not know how to set Z0 or a Z home first.
Would appreciate the assistance greatly.
Ray
Setting Z0
Moderator: cnckeith
-
CA44vivr44
- Posts: 6
- Joined: Fri Dec 13, 2024 12:02 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 98F07B922A04-0911248486
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Setting Z0
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
ShawnM
- Community Expert
- Posts: 2923
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: Setting Z0
Have you read the section that covers this in the Mill Operators Manual? See chapter 4.
https://www.centroidcnc.com/centroid_di ... manual.pdf
https://www.centroidcnc.com/centroid_di ... manual.pdf
(Note: Liking will "up vote" a post in the search results helping others find good information faster)