Centroid Community CNC Support Forum

Hi,

I've got one of the DC powered switches with my Eth1616 which is a welcome addition. Ive been using another switch in the meanwhile but now keen to install this one. Its got two sets of inputs, which do I use on 24V DC please? The docs show the spec of it, not any wiring info. I also dont see any wiring info amongst the Centroid diagrams.

Thanks

This looks like the same switch, perhaps different label but same connector etc. On this it suggests that V1 and V2 are 2 different sources in case you wanted resilience? So use use V1 - as GND and V1 + as 24V DC?

https://www.amazon.co.uk/MokerLink-Indu ... r=8-5&th=1

Please see the attached schematic for wiring the Switch.

Perfect, thank you, as assumed. Not powered it on yet, still busy rewiring.