Centroid Community CNC Support Forum

Centroid CNC Manuals.
https://www.centroidcnc.com/centroid_di ... nuals.html

How to Configure Windows 10/11 for CNC control use.
https://www.centroidcnc.com/dealersuppo ... ds/309.pdf

Centroid CNC Hookup and System schematics
https://www.centroidcnc.com/centroid_di ... .php?term=
use the search!

Centroid CNC software downloads.
https://www.centroidcnc.com/centroid_di ... loads.html

Encoder Basics
https://centroidcncforum.com/viewtopic.php?f=64&t=4

DC servo motor Encoder retrofit upgrade
https://www.centroidcnc.com/sem_dc_serv ... rofit.html

Centroid CNC support youtube video channel.
https://www.youtube.com/@CentroidSupport

20 year old mill training video, the basics still apply. WCS, Tool heights etc.
for Bed Mill


for Knee Mill


Oak Bench Test Video.
https://centroidcncforum.com/viewtopic.php?f=64&t=3238

Allin1DC control installation video.
https://centroidcncforum.com/viewtopic.php?f=64&t=2421

Machine Tool Coordinate Systems and Conventions.
https://centroidcncforum.com/viewtopic.php?f=64&t=3638

Centroid Tech Bulletins
https://www.centroidcnc.com/centroid_di ... browse.php

Intro to Macro Programming
https://www.centroidcnc.com/centroid_di ... amming.pdf

CNC12 Virtual Control Panel Users Guide
https://www.centroidcnc.com/centroid_di ... manual.pdf

Tool Height, WCS Part Zero, Machine Coordinate explanation
https://www.centroidcnc.com/centroid_di ... rement.pdf

WCS made easy
https://www.autodesk.com/products/fusio ... made-easy/

Centroid G-code Smoothing users manual.
https://www.centroidcnc.com/centroid_di ... manual.pdf

Using the CNC12 PLC Input Output diagnostic screen documentation.
https://www.centroidcnc.com/centroid_di ... screen.pdf

Marty's CNC Garage Video Channel
https://www.youtube.com/channel/UCTNt9I ... GVQ/videos

newbie Centroid PLC programming video series..


How to add a simple safety switch input to a PLC program
https://www.centroidcnc.com/dealersuppo ... ds/314.pdf

CNC12 PLC programming manual http://www.centroidcnc.com/centroid_diy ... manual.pdf

PLC Detective users guide.
https://www.centroidcnc.com/downloads/c ... kstart.pdf

Just doing the voltage bench test on the allin1 dc I put in my mill and a line says I need to close the door first. I don’t have a door switch. Is there a parameter I need to shut off so I can continue my setup. Thanks

1936hotrod wrote: ↑Mon Apr 28, 2025 2:39 pm Just doing the voltage bench test on the allin1 dc I put in my mill and a line says I need to close the door first. I don’t have a door switch. Is there a parameter I need to shut off so I can continue my setup. Thanks

please start a new thread