CNC12 Tangential Knife
Posted: Wed Dec 11, 2024 12:09 pm
Hello All.
Thought I'd make a Topic On setup and use of a Tangential Knife with CNC12
Setting an axis for Tangential Knife is Available on all Centroid controls on Software version 5.08 and newer.
The CNC12 Tangential Knife Axis Setup TB can be found here: https://www.centroidcnc.com/dealersuppo ... ds/333.pdf
I have the EcoCam Oscillating Tangential Knife mounted on my AcornSIX Brained 4x4 Router.
The EcoCam has a Closed Loop Stepper that Turns the Knife with an Overall Turns ratio of 1:1 at 3200 Steps per revolution.
I Created a Tangential Knife Photo album where I have a Video Cutting the Centroid LOGO out with the Knife on some 3/16th inch Foam board.
Also I have some video's explaining how I created the G-code in Sheetcam and how to modify the post for Sheetcam so the post matches my machine.
Check out My Tangential Knife Album here:
Thought I'd make a Topic On setup and use of a Tangential Knife with CNC12
Setting an axis for Tangential Knife is Available on all Centroid controls on Software version 5.08 and newer.
The CNC12 Tangential Knife Axis Setup TB can be found here: https://www.centroidcnc.com/dealersuppo ... ds/333.pdf
I have the EcoCam Oscillating Tangential Knife mounted on my AcornSIX Brained 4x4 Router.
I Created a Tangential Knife Photo album where I have a Video Cutting the Centroid LOGO out with the Knife on some 3/16th inch Foam board.
Also I have some video's explaining how I created the G-code in Sheetcam and how to modify the post for Sheetcam so the post matches my machine.
Check out My Tangential Knife Album here: