Can I use a Pendant from a DCIO3 with an AllinOne

[Exhibitology]

Greetings,

I've almost finished upgrading a Aciera mill from a DCIO3 to an AllinOne controller.

Can I use the wired MPG from the DCIO3 with the AllinOne system?

It is an EHDW-BA5S-IM.

If so, is there a pinout for the conversion?


Thanks

[centroid467]

I'd take a look at page 12 of the ALLIN1DC individual circuit set S14996 (https://www.centroidcnc.com/dealersuppo ... df#page=12) and the CNC10 MPG cable schematic S14619 (https://www.centroidcnc.com/dealersuppo ... 619.r1.pdf)

[cncsnw]

No.

The old MPG handwheel pendant has a single-ended encoder (one wire per channel).

The Allin1DC requires an MPG handwheel with a differential encoder (two wires per channel).

[Exhibitology]

Thanks again CNCSNW!