Page 6 of 6
Re: Build Thread- Tree Journeyman 425 to Allin1dc
Posted: Sat Jul 19, 2025 8:52 pm
by glbreil
Sounds like the switch isn’t changing state every time you trip it. Can you trip the switch manually and see what happens? Assuming they are normally closed then there could be chips or something like that in the switch or maybe the machine isn’t contacting the plunger enough. Gary
Re: Build Thread- Tree Journeyman 425 to Allin1dc
Posted: Sun Jul 20, 2025 9:34 am
by frankljs
Yeah your probably right. Manual trips work fine. I switched out the terminal in the switch, but I will check again and see if the installation was no t right.
Re: Build Thread- Tree Journeyman 425 to Allin1dc
Posted: Mon Jul 21, 2025 3:40 pm
by frankljs
I adjusted the -y limit switch and reset software limit. Saved rebooted and reattempted system test. Passed System Test!
Re: Build Thread- Tree Journeyman 425 to Allin1dc
Posted: Mon Jul 21, 2025 5:51 pm
by frankljs
Video of first cuts posted. Very pleased with the performance so far.
On another note, my servos are getting a bit too warm, what should I adjust to reduce this? Thanks
Re: Build Thread- Tree Journeyman 425 to Allin1dc
Posted: Mon Jul 28, 2025 8:56 am
by frankljs
I lowered the Kp from 1.0 to 0.8, which appeared to help a little, but can anyone give any advice on how best lower the temp on the servos? Everything works fine, but temp is warmer than id like. I ran the auto tune during setup and after putting in the recommended numbers for kp 1.0, ki 0.004,and kd 3.0
There’s a fresh report post above if you need. I have baldor 40inlb servo pic posted in album.