Page 2 of 2
Re: "shot pin tool change orientation"
Posted: Thu Jul 29, 2021 3:40 pm
by Apolo1969#
Im going to get rid of the shot pin orient, look like everybody have hard time to make work with centroid.
i just going to get one of those chinese spindle and match drive from Atomation Technologies!
it seem Centroid is more for use with modern Servo VFD.... I just ordered one kit!
Re: "shot pin tool change orientation"
Posted: Fri Jul 30, 2021 10:31 am
by martyscncgarage
Apolo1969# wrote: ↑Thu Jul 29, 2021 3:40 pm
Im going to get rid of the shot pin orient, look like everybody have hard time to make work with centroid.
i just going to get one of those chinese spindle and match drive from Atomation Technologies!
it seem Centroid is more for use with modern Servo VFD.... I just ordered one kit!
You will need a good spindle motor, you'll need a good spindle encoder, good VFD with optional Encoder board and has Spindle orient input capabilities.
And understand how to set it up.
I don't think the shot pin orient was a deal breaker, I would have probably tried to work with that first.
Good luck with your project in any case!
Marty