Centroid Community CNC Support Forum

Like Tom said. This should only happen once.
Have you powered down and back up and rehomed? Should not have recurred. If it did, a limit switch would be my first suspect. It's not repeatable. Usually cheap limit switches could do this.

At least your moving forward.....

Marty

Ok cool. Because I rebooted and homed again and no message. The only message I get now is at boot up. It has not set up contact technician. I don’t know if that is normal

Deon wrote: ↑Sun Jun 23, 2019 11:01 am Ok cool. Because I rebooted and homed again and no message. The only message I get now is at boot up. It has not set up contact technician. I don’t know if that is normal

That is normal, until you run the test. My videos go through that.
Make sure you have followed the installation manual to a T. My videos help with that.

You are on your way. Congratulations....
Marty