Centroid Community CNC Support Forum

i figured it was communicating, but how do you reboot the acorn board at that point?

just remove power from acorn wait about 10 seconds and plug it back in

this is all i get after update, and unplugging the board and plugging it back in, then starting cnc12 again.

not sure why vid didnt post, here it is again

not sure why vid didnt post, here it is again

its been sitting like this for twenty minutes now lol. its got the flashing green light next to ether, net plug but just sits and says establishing comm, but cnc12 doesnt come up.

so after 25 minutes, the communications error pops up. im not sure what to do lol. this is as far as i can get.

pic shows laptop? That is not supported by centroid

viewtopic.php?t=1914

ok,,,, i had it on my monitor, switched to laptop to see if it would get anywhere. so same on both. there has literally been nothing hooked up or changed for this board to be doing this. i should have juast went ahead and contacted centroid the first few times it kept giveing communications errors, but with the family medical stuff we dealt with it had to wait. and haveing read that people unplug them, then plug them back in and have success, i tried it, it worked a few times, and now nothing at all, even shows the quick flash like its connected bit after 25minutes gives the communications error

here is a pic of it hooked back up to monitor ken,,,,,, also, the main pc is the nuc pc they recommend, thats what i bought, thats what im useing, i just tried it on my laptop to see if it would get anywhere.

same thing after 25 minutes of flashing like its connected but saying establishing communications, it gives the communications error.