I have a turning center on which I want to install a **Centroid CNC Oak control**. This machine is equipped with **live tooling**, and the live tool is driven by a **servo motor drive**.
I need guidance on how to operate the live tool with this setup. Additionally, if you have any relevant documentation, wiring diagrams, or configuration data related to **Centroid CNC Oak control and live tooling integration**, please share it with me.
Machine Pictures attached.
Looking forward to your expert advice.
Live Tool In Turning Centre
Moderator: cnckeith
-
- Posts: 2
- Joined: Fri Oct 11, 2024 11:34 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Live Tool In Turning Centre
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Community Expert
- Posts: 3532
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: Live Tool In Turning Centre
As far as I know there is no second independent spindle speed control with Centroid right now.
Workaround is to use outputs to drive the live tooling with preset speeds.
Uwe
Workaround is to use outputs to drive the live tooling with preset speeds.
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)