I am thinking of retrofitting a VMC milling machine with the Oak board. The motors that i am fitting have incremental differential encoders 2500 lines
Will these be suitable for the Oak board?
Oak encoder type
Moderator: cnckeith
-
PhilipTrueman
- Posts: 94
- Joined: Thu Sep 21, 2023 10:13 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: United Kingdom
Oak encoder type
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
tblough
- Community Expert
- Posts: 3523
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Oak encoder type
Those should be fine. You'll most likely have to change the wiring to Centroid's standard.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)