Here is a video of my newest Electronic Edge Finder. At touchdown, it feeds a contact closure to the auto touchdown function of CNC12. My probe is an uninsulated piece of 3/8" drill rod. Total cost is under $5. Not much hardware, but a fair amount of software runs on the Arduino ATTiny85.
Full documentation to follow..
Rick
A Software Defined Edge Finder Video
Moderator: cnckeith
-
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
A Software Defined Edge Finder Video
(Note: Liking will "up vote" a post in the search results helping others find good information faster)