Thanks this works, just tested. Did not know that P292 is for AUX13 ect. It is not Not in the manual...cncsnw wrote: ↑Wed Mar 15, 2023 1:42 pm From the VCP buttons definition in his report:
"One Shot Chamfer" sends skin event 19.
The PLC recognizes skin event 19 as Aux11, and uses it to trigger "DoAux11Key"
"DoAux11Key" would run whatever function you specified with Parameter 198.
"One Shot Turn" sends skin event 20.
The PLC recognizes skin event 20 as Aux12, and uses it to trigger "DoAux12Key"
"DoAux12Key" would run whatever function you specified with Parameter 199.
"One Shot Lathe Facing" sends skin event 66, Aux13, DoAux13Key, Parameter 292.
"One Shot Radius" sends skin event 67, Aux14, DoAux14Key, Parameter 293.
"One Shot Lathe Drill" sends skin event 68, Aux15, DoAux15Key, Parameter 294.
So you need to set some parameters, as Uwe indicated, but not parameters 188-192. Instead you need to set those values in parameters 198, 199, 292, 293 and 294.
Centroids One shots are different from mine setup
Uwe