I'm using ACORN_rev4 MULTIPLE KL-5080H HYBTID DRIVES. It shows Step 1,2,3 Direction 1,2,3, using H6 (DB25) and Enable 1,2,3 using H2 and H3.
In ALL the videos I have watched ALL the terminals are used are H2, H3, and use shielded wire. Any clarification would be greatly appreciated.
Different schematic
Moderator: cnckeith
-
Tymco
- Posts: 7
- Joined: Mon Jan 17, 2022 5:00 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 98F07B922A67-0118236786
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Pismo Beach
Different schematic
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3651
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: Different schematic
H6 is 5V, most steppers run better with this.
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
ShawnM
- Community Expert
- Posts: 3030
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: Different schematic
And shielded wire is preferred for the step and direction signals.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)