As Tom points out, you can use any of the three.
However, prevailing practice on two-speed machines is to use low (P65) and high, and skip the two middle ranges.
Spin High/Med/Low
Moderator: cnckeith
-
cncsnw
- Community Expert
- Posts: 4600
- Joined: Wed Mar 24, 2010 5:48 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
Re: Spin High/Med/Low
(Note: Liking will "up vote" a post in the search results helping others find good information faster)