New Control Box for 2 Axis Lathe, Leadshine Closed Loop Drivers and Motors

[GBCues]

Here is my new control box that I've been working on for a couple of months. It's a 16x20x10 Hoffman box I scored on Craigslist for $50

120V Power comes in the left top to a 25 Amp circuit breaker. From there individual leads go through fuses before powering the individual power supplies, except for the 36V psu and the VFD. Those leads go through a contactor first which gets tripped by a relay on the Acorn board once the Acorn boots up successfully. The VFD is front ended by an EMI filter.

This is a 2 axis machine running Leadshine drivers and NEMA23 closed loop motors.

Thanks to Gary Campbell and Jim Dawson for design ideas and Marty and Keith for troubleshooting help.

[cnckeith]

nice clean looking install! thanks for posting!