Offset Library wont upload to Tool Library

[Turbodime]

New member here. I have a Centroid ran knee mill with Centroid 4th axis. Watching the Centroid vid we are at step #4, Programming the Part with Intercon. We have tools in the Offset Library but nothing comes up in the Tool Library. How do we transfer these tools into the tool library? Thanks for any help.

Aaron

[martyscncgarage]

New member here. I have a Centroid ran knee mill with Centroid 4th axis. Watching the Centroid vid we are at step #4, Programming the Part with Intercon. We have tools in the Offset Library but nothing comes up in the Tool Library. How do we transfer these tools into the tool library? Thanks for any help.

Aaron

Aaron, you should create the tool library first. Then do you tool offsets.

[Turbodime]

Thanks we'll look into that. We were following along with the video and it starts with offsets first. We'll start over with manual in hand as we'll I see you're in Mesa. I watched some of your vids and I instantly recognized you. We worked for the same place.

[martyscncgarage]

Thanks we'll look into that. We were following along with the video and it starts with offsets first. We'll start over with manual in hand as we'll I see you're in Mesa. I watched some of your vids and I instantly recognized you. We worked for the same place.

Start the mill training videos over and watch carefully. Yes, the Mill Operators manual is a good resource. Check out the section on INTERCON. There are some tutorials you can try out to get your feet wet.

Worked for the same place? You've got my attention.