Any recommendations to source mushroom estop switch?

Geoman_Tony · Post by **Geoman_Tony** » Mon Jun 11, 2018 1:23 pm

Greetings,

This is an easy one. Does anyone have any recommendations on where to source (at a reasonable price) a mushroom style, E-stop switch with two sets of normally closed contacts to use with my Acorn/Gecko (drive only) set up? Ebay has plenty of E-stop switches, but most have one each of NO & NC contacts.

Thanks in advance.
Geoman_Tony

Post by **cnckeith** » Mon Jun 11, 2018 4:00 pm

about 3/4 the way down this page. http://www.centroidcnc.com/centroid_diy ... oller.html

trottrr50 · Post by **trottrr50** » Mon Jun 25, 2018 11:06 am

Another option is to take two of the estops that have one NC and one NO circuit and convert them into an estop with two NC circuits. I have been using estops like this for a while and have had no problems. See the attached links for information on doing this. Its pretty simple to do.

http://www.cnczone.com/forums/vertical- ... cnc-4.html

viewtopic.php?f=60&t=1431&p=8606&hilit=trottrr50#p8599

DICKEYBIRD · Post by **DICKEYBIRD** » Tue Jun 26, 2018 2:14 pm

I use these: https://www.ebay.com/itm/DECA-A20B-V4E0 ... SwgQ9Vy-SJ They come with one NC switch unit but will accept up to 2 more switches, NC or NO. Additional switches are available separately and just snap in.

Centroid Community CNC Support Forum

Any recommendations to source mushroom estop switch?

Any recommendations to source mushroom estop switch?

Re: Any recommendations to source mushroom estop switch?

Re: Any recommendations to source mushroom estop switch?

Re: Any recommendations to source mushroom estop switch?