Complete VMC Oak Retrofit Kit 5 axis

[m50vince]

I bought this back in 2021 to do a retrofit but never got around to it. It is all still in the crate. The machine I have to install it on is a Hardinge VMC 1000II. The machine is in great shape and has never been used to cut metal or had coolant in it. It was only used for 3 years to cut wood and some plastics and then it sat and lost the batteries. It will power up, but all the backup is gone. And I have a Troyke L Series 10" 5th axis rotary table. I will sell it all or just the retro kit.



1 15000 Oak CNC Control board assembly for Servo Pro and Ultimate
1 10827 Enclosure M400 ac atc 3kw (Wire Cabinet)
1 7670 Large Cabinet 36 x 34 x 13
1 15004 Mill Ultimate for Allin1DC, OAK, MPU11, Hickory
1 15006 ATC Support PLUG IN / Software Levels Servo
1 11025 PLCADD1616: PLC Expansion Card (16 inputs and 16 relay outputs)
5 13134 5' OAK Cable, LC4D to Yaskawa Sigma V, S14530
1 12554 OpticDirect Yaskawa
1 13166 CNC11-C 5+ axis Simult Software
1 13181 CNC Console w/ built-in CNCPC M400 ATC
1 11028 Console ext. cable in conduit (6 ft conduit, 16 ft cables)
1 13932 Slimline Console to Mounting Arm Hardware
2 14385 3KW Motor and Drive, SGMGV-30ADA6S motor w/shaft seal and SGDV-200A01A amplifier
1 14389 3KW Motor and Drive SGMGV-30ADA6E brake motor w/ shaft seal and SGDV-200A01A drive
3 6795 10 meter Encoder cable w/ rt angle connector (drive to motor) 1kw + motorsYaskawa
3 6944 10m 3Kw Motor Power cable (drive to motor)
1 6828 10m Brake power cable w/ rt angle connector (drive to motor)
1 14944 KP-3 Complete Kit, AllinoneDC / OAK servo
2 14384 2KW Motor and Drive, SGMGV-20ADA6S motor w/ shaft seal and SGDV-180A01A amplifier,, 200V
2 6795 10 meter Encoder cable w/ rt angle connector (drive to motor) 1kw + motorsYaskawa
2 6807 10m 2Kw Motor Power cable (drive to motor)
1 11069 100 Step Manual Pulse Generator (MPG), MPU11 System Mill
1 14214 Wiring and PLC work for 4th and 5th axis air brake

I have over $46,000.00 invested but would sell it all for $35,000.00. That is less than then just the kit cost me.


Email me if you would like to see the Centroid invoice or pictures of the machine. vince@delkronmfg.com
I have a way to load the machine in a flat bed.