martyscncgarage wrote: ↑Mon May 04, 2020 9:27 am
Looks right because it shows the inputs with a negative number but you'd better contact them to make sure its NPN
Thanks marty,, contact has been made, NPN is confirmed,
Do you have basic electrical/electronic skills?
Very important to be successful and to be able to work your way through the conversion.
Use the Generic VFD wiring as a guide.
You will connect 24VDC from Acorn logic power supply to the COM terminal of that relay board.
You have 8 relays. The older revision Acorn board has two relays on it.
You will take Outputs 3-8 on Acorn to Inputs 3-8 on the relay board.
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
martyscncgarage wrote: ↑Fri May 15, 2020 1:52 pm
Do you have basic electrical/electronic skills?
Very important to be successful and to be able to work your way through the conversion.
Use the Generic VFD wiring as a guide.
You will connect 24VDC from Acorn logic power supply to the COM terminal of that relay board.
You have 8 relays. The older revision Acorn board has two relays on it.
You will take Outputs 3-8 on Acorn to Inputs 3-8 on the relay board.
Hi, my output 4 for spindle foward is seem not respone,, can i use output 3 for spindle foward, and how to repair output4 if is damage,, i think i use those ouput4 to power some relay at the first place ,, maybe i made a wrong connection,,
Rosmadi wrote: ↑Sun Jun 07, 2020 10:04 am
Hi, my output 4 for spindle foward is seem not respone,, can i use output 3 for spindle foward, and how to repair output4 if is damage,, i think i use those ouput4 to power some relay at the first place ,, maybe i made a wrong connection,,
ALWAYS post a fresh report when asking for help Rosmadi.
Please post pictures of how you wired up the relay.
Post a screen shot of your Wizard input and output screens.
You need to make sure you wired that relay board correctly FIRST.
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ