Centroid Community CNC Support Forum

5.32 software fixed the problem, it jogs fine now.

Thank you

I have no other components to try at this time.
But because it runs on the LS software I wound think motor and cables are fine.
I don't know about you but it seems the drive is the likely problem at this time.
Hopefully just configuration.
Here is the parameter file I think I copied it correctly ...

Just doing bench test on my new hickory. Everything was going good until I try to jog motor. (I only have one axis for now) Then I get 9043 X Axis Drive Fault. If I hold on to the motor shaft I can fill it start to move. I have Encoder connection. ((I have jogged the motor and drive with the LS ...