Centroid Community CNC Support Forum

Thank you for the reply.

Having issues with Y axis exceeded. Attached is my report and an .nc file it errors out on for example. A simple drill op that the error comes at line 25 almost at the end of the program. I've reset coordinates at a couple places that would more than allow the small travel that is in the op. Any ...

Has anyone had contact with SWISSI lately? I've sent him a couple e-mails with no response, hasn't signed on here since August 1st, hope all is well with him.

Thank you for all of your help.

Donald

While I was in the middle of a tool check we lost power. Is there anyway to re-start G-Code at a certain line number?

Thank you
Donald

Thanks, Ken, found a loose wire on the analog terminal. Tightening up fixed the problem.

Donald

Just remove the analog control wires from Acorn and hook them to a 9v battery?

Donald

Having an issue with controlling spindle speed with my Acorn build. Attached is my report. I did the spindle bench test with no issues, but now I get no change in the Analog output after changing the slider on the VCP or give a M3 S* command through midi. The spindle spins as soon as it is turned on ...