Page 1 of 1

When the Centroid CNC Software Loses its Acorn (resolved)

Posted: Fri Sep 15, 2017 10:00 am
by RGSparber
Recently my new Centroid Acorn CNC system started to complain. After receiving help from Centroid plus doing some poking around, I found a double fault. Somehow a virus program had been installed and was active. I also bumped the Ethernet cable and it was not making full contact. All is well again. This was not a hassle, it was an opportunity to write up my debugging steps.

If you are interested, please see

Your comments are welcome. All of us are smarter than any one of us.