It is not much to see, but is a milestone to me. Lots of things worked perfectly for me to make this simple cut around a cube:
Home at the push of a button
Tool Touch Off to set tool height
Tool Offset via G code
X Box Controller
Part 0 with my Electronic Edge Finder which uses my Reference Tool
plus a few simple lines of G code in a file:
Rick
First cut using Centroid Acorn and a G code file
Moderator: cnckeith
-
RGSparber
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
First cut using Centroid Acorn and a G code file
(Note: Liking will "up vote" a post in the search results helping others find good information faster)