Page 1 of 1
pc broke
Posted: Wed Dec 20, 2023 1:23 pm
by Rosmadi
hi all, been so long not in here, need some help, pc that running cnc has broke, cant swicth on. by new pc, install software, but evrything seem alien to me now,, how to set the congfiguration , any video please. help
Re: pc broke
Posted: Wed Dec 20, 2023 1:52 pm
by suntravel
No backup on a USB or cloud?
You can also try to read out the old HD with an adapter on the new PC and copy the folders.
Uwe
Re: pc broke
Posted: Wed Dec 20, 2023 3:16 pm
by cnckeith
suntravel wrote: ↑Wed Dec 20, 2023 1:52 pm
No backup on a USB or cloud?
You can also try to read out the old HD with an adapter on the new PC and copy the folders.
Uwe
thats what i would do. plug the old HD into a new PC and copy out the CNCM and Intercon directories.
for the new pc be sure to run the Centroid PC Tuner and follow the final steps in TB309 to get it setup up for CNC user first!
https://www.centroidcnc.com/dealersuppo ... ds/309.pdf
Re: pc broke
Posted: Wed Dec 20, 2023 3:17 pm
by cnckeith
if the old HD is trashed. then set up the new PC with the wizard by following Acorn Installation manual after you run the PC tuner.
this kind of stuff is why it is recommended to make backup copies of at least a "report.zip" or the entire CNCM direction and store them off the CNC PC in a safe location.
