Page 1 of 1
Set Acorn to not ask me to switch tool. Chucker mode.
Posted: Tue May 16, 2023 9:55 am
by ChrisMe
I'm using my lathe in chucker mode so how do I set acorn to not ask me to change tool but to just go from toll 1 to tool 2 to tool 3 automatically?
Re: Set Acorn to not ask me to switch tool. Chucker mode.
Posted: Tue May 16, 2023 10:02 am
by suntravel
Set parameter 6 to 1, this enables auto tool change.
Uwe
Re: Set Acorn to not ask me to switch tool. Chucker mode.
Posted: Tue May 16, 2023 10:18 am
by ChrisMe
suntravel wrote: ↑Tue May 16, 2023 10:02 am
Set parameter 6 to 1, this enables auto tool change.
Uwe
Thank you. Where do I find the parameter menu?
Re: Set Acorn to not ask me to switch tool. Chucker mode.
Posted: Tue May 16, 2023 10:23 am
by suntravel
pls read the manual....
Uwe