GECKO G201X STEPPER DRIVE PINS For 3 x AXIS ? What pin numbers

[adamfromscotland]

Hey you guys!

Im back doing my install again i using the Gecko drives and followed Acorns diagram for the stepper motor wires go this is awesome, but what pins do i use for Y,Z And A Axis?

Ive installed the first one X Axis to pins 2.3 and 18

whats pins do i use for my NEMA 23 Gecko drivers for the 3 x remaining axis?

Many thanks

adam

[Sword]

It's right there in your attached diagram, the rectangular outlined area listing all the pins for the DB25 connector (H6).