Page 1 of 1
oak board
Posted: Tue May 03, 2016 12:26 pm
by larryl
at what point does relay 1 close (e stop) . on start up of cnc ?
Re: oak board
Posted: Tue May 03, 2016 12:55 pm
by Centroid_Tech
As soon as the CNC11 software is loaded and as long as the CNC11 software is not in a fault state, output 1 which is the NoFaultOut output will turn on.
Re: oak board
Posted: Tue May 03, 2016 12:57 pm
by larryl
thank you