Page 1 of 1
tool sheet labeling?
Posted: Fri Feb 10, 2023 6:18 am
by Black Forest
How can I get my tool sheets to have the same program name and number as the G-code file I am posting? Mine always are labeled tool sheet for program 1001. I have looked in the post processor and other places but I have not found it yet.
Re: tool sheet labeling?
Posted: Fri Feb 10, 2023 6:35 am
by suntravel
fusion360 uses the Program# you have written in SetupX\Post Process for the sheet.
Uwe
Re: tool sheet labeling?
Posted: Sat Feb 11, 2023 2:49 am
by Black Forest
Not in mine! I set the program number in the post processor say for example 1111 but my tool sheets always come with 1001.
Re: tool sheet labeling?
Posted: Sat Feb 11, 2023 5:09 am
by suntravel
Set the number in the setup for the toolpath, not in the PP setup
This is where the sheet gets the number from, and the PP also.
Uwe
Re: tool sheet labeling?
Posted: Sat Feb 11, 2023 7:05 am
by Black Forest
OK. That was the problem. Thank you Uwe! I missed you on the forum.
