Centroid Community CNC Support Forum

Today we were running job on a mill (Centroid, All in one DC) and feed hold (we don't have a pendant, so use space bar on keyboard) would not respond. Right above the task window we could see FEED HOLD highlighted with red. The job was running fine, though. Is it a known issue? Is there any other way to stop in the middle of the job?

Thanks, Mark

Marik,

When requesting support, please always post a current report.zip from your system or email it to tech@ajaxcnc.com

We haven't seen this issue on other systems and without a report we can't determine what the cause might be.