Afternoon everyone, I'm moving in a few directions today on the DC-AIO install for a SuperMax YMC30. You guy's have been great so far! So thanks. A question on the contactors for the e-stop and flood please? For the use of the eStop Conntactor and Flood Contactor @ 24VAc, I see the e-Stop 4 contactor arrangement and a similar contactor for Flood- But I've honestly never seen the item you describe as an OCR? (OCR2) And if there are two of them, I could not find #1?
TIA,
JJ
Into LV contactor hookups.
Moderator: cnckeith
-
countryguy
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Into LV contactor hookups.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
countryguy
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: Into LV contactor hookups.
Yeah- I got it now- Over Current Relay.... This would / should be the OCR flood w/ overload protection. OK....
(Note: Liking will "up vote" a post in the search results helping others find good information faster)