Centroid Community CNC Support Forum

I hope you all are doing well.

Its been a while since my last post.

I was usisng my controller without any issues, like two or three years ago , I just shut it down , now Im going back and im facing an issue with the Pendant , I can see its conected and when I jog the any axis the screen on the Pendant track the position , meaning it is updating the DRO , but when I switch to the pendant is not jogging , Im pressing the key to activate the pendant in the VCP but the red mark in the Top corner does not change and the pendand is not enabled.

Can you please help me out ?

Do I have to update the software since I been out for a while ?

Please have a look at the attached report.

Thannks in advence

rotate the axis selector knob off the off position onto an axis, x,y,z,4th and the LED on the VCP will illuminate letting you know the MPG is active

Many thanks for your soon answers Keith

Just restarted and now is working , that was weird , i did that previosly and did not worked , but now is ok.

Thanks for you support.

no worries. glad you got it going.