Page 1 of 1
New Acorn with bent pin
Posted: Mon Jun 20, 2022 4:52 pm
by akschu
Just got my new Acorn from cnc4pc and noticed this. Should I pull the board off and straighten it?
Re: New Acorn with bent pin
Posted: Mon Jun 20, 2022 5:27 pm
by tblough
Either that or return it for replacement.
Re: New Acorn with bent pin
Posted: Mon Jun 20, 2022 6:04 pm
by akschu
I bent the pin back and it seems okay, so I think I'll just roll with it, but good to have this documented in case something breaks down the road.
Re: New Acorn with bent pin
Posted: Tue Jun 21, 2022 9:00 am
by Centroid_Liviu
Thank you for bringing that to our attention. That is clearly not how that Acorn should have shipped out. The pin in question is one of several ground pins so it will have no effect on the function of the Acorn, however we would be happy to issue an RMA. Please let us know the serial number on the Acorn so we can at least document this.