Hello, I am wondering if anyone has a similar lubrication system and if you found a way to control it by the OAK PLC.
My is pneumatically actuated via a solenoid. I also have a low lube sensor (already connected to IN9), and another NC/NO sensor for cycle complete.
My problem is that this pump can only run 4 times/min. and I need at least 8 ON/OFF to complete a cycle.
Any help is much appreciated
Pneumatic Pump Lubrication Sysyem
Moderator: cnckeith
-
carocad
- Posts: 16
- Joined: Fri Jun 11, 2021 2:17 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Pneumatic Pump Lubrication Sysyem
(Note: Liking will "up vote" a post in the search results helping others find good information faster)