Centroid Community CNC Support Forum

Is it possible to install and use an AC servo with a DC3IOB/MPU11 kit.
I have purchased a Nikken rotary table thinking I would change over the servo, I think I can do it buy I'll have to disassemble a spare servo I have and put a taper and a key on it. Worried about even small amount of run out.
I am about to make a big push to finish my project. Now going to have a 4th axis.

Chris

The intelligent input pins on the Hitachi are all programmable. The DEFAULT reset may be pin 5, but it is easily programmable to be whatever pin you want.