Centroid Community CNC Support Forum • 3D Probe specs (Resolved)

Page 1 of 1

3D Probe specs (Resolved)

Posted: Mon Apr 26, 2021 2:32 pm

by Christian Wahl

hello Acorn friends

I'm going to buy a probe, and my question is what functions this must have.
I have the following options:

I have gone for a European supplier due to customs duties and taxes.
https://www.slavtec.eu/index.php/produc ... tip-kopia/

Best Regards Christian

Re: 3D Probe specs

Posted: Mon Apr 26, 2021 4:24 pm

by cnckeith

https://www.centroidcnc.com/centroid_di ... _setup.pdf

Re: 3D Probe specs

Posted: Tue Apr 27, 2021 1:22 am

by Christian Wahl

Thanks Keith
I knew I had seen this pdf somewhere in the forum, but could not find it again in the information jungle.

Re: 3D Probe specs

Posted: Tue Apr 27, 2021 2:43 pm

by cnckeith

no worries.. for future reference All Acorn documentation is located in the "All Acorn Documentation" thread here.

viewtopic.php?f=60&t=3397